Typical evaluation scope
Ready-mix, precast and high-flow concrete.
Liquid polycarboxylate water reducer
PCE Superplasticizer Liquid
PCE superplasticizer liquid is intended for concrete production systems where pumpable liquid dosing is preferred. Select the grade according to water-reduction, workability-retention and cement-compatibility requirements.
Liquid delivery formReady-mix & precastWater-reduction and retention grades
Product role
Where this product fits
PCE superplasticizer liquid is intended for concrete production systems where pumpable liquid dosing is preferred. The company catalogue describes broad compatibility with Portland, slag, fly-ash and pozzolanic cement systems, subject to trial-mix confirmation.
Important: confirm the current grade and
evaluate performance in project materials before commercial use.
Technical overview
Catalogue product information
| Property | Catalogue value |
|---|---|
| Physical form | Liquid |
| Solid content | 40-50% |
| Water reduction | Up to 35%+ |
| Workability | Low slump loss; designed for pumpable concrete |
| Suggested applications | Precast and cast-in-place, reinforced and prestressed concrete |
Values are retained from the company catalogue and remain indicative. Request the current grade-specific TDS and confirm performance in project materials.
Inquiry checklist
What to send with your request
01 · Application
Concrete use or PCE synthesis route.
02 · Target
Required grade and performance objective.
03 · Quantity
Sample, trial or estimated order volume.
04 · Destination
Country, port and packaging needs.
Buyer-oriented technical selection
Liquid PCE selection
Factors that change performance
Solid content, water-reduction/slump-retention balance, density, ph and chloride/alkali limits.
Recommended verification
Dose on product mass or active solids consistently and add separately from incompatible admixtures.
Documents and evidence
Ask for the current grade specification and batch documentation. Review available company certificates, test evidence and supplier batch-report scope separately.
Plant-fit checklist
Specify liquid PCE by process, not appearance
A liquid grade should be matched to the buyer's cement, target workability window, dosing equipment and delivered concentration. Colour alone does not identify performance or equivalence.
Delivery and storage
- Confirm active-solids basis and net product mass.
- Review tank, pump and transfer-line compatibility.
- Use the current storage and temperature instructions.
Concrete trial
- Keep mixing sequence and water adjustment controlled.
- Measure initial and retained workability.
- Review air, setting and strength with the full admixture stack.
Choose the delivery form
Compare PCE powder, liquid and flake
Delivery form changes handling, dissolution and dosing—not the need for grade-specific compatibility testing. Start with the form that matches the buyer's process, then request the current specification.
Compare liquid with powder and flake
Use the comparison to prepare the grade, process and document questions for your inquiry.
HFC-1001 grade and supplied document
HFC-1001 Liquid PCE Superplasticizer — grade-specific properties, application boundaries and document review status.
Original product data sheet (Chinese PDF). Supplied original, unchanged; naming/revision details require confirmation. This file is not a batch COA or independent certification.
Grade-specific buying brief
Confirm whether the liquid offer is concentrate or finished admixture
A liquid PCE quotation needs the supplied solids concentration and the intended use. Identify whether you need a polymer concentrate for blending or a finished admixture for a concrete plant. When comparing price or dosage, record whether the calculation uses delivered liquid or active solids; equal percentages on different bases cannot be compared directly.
Include the water-reduction and retention objectives separately, together with cementitious materials and temperature. Request grade-specific density with its unit and test temperature before converting a mass-based quotation to volume. Current container, storage and shelf-life details should match the actual supplied concentration.
Details for a matched sample and quotation
- Supply role and current solids specification
- Dosage denominator and delivered-product/solids basis
- Required retention window and cement compatibility context
- Density method, packaging, current TDS/SDS and COA